FN Archimer Export Format
PT J
TI Entire Life Time Monitoring of Filament Wound Composite Cylinders Using Bragg Grating Sensors: I. Adapted Tooling and Instrumented Specimen
BT 
AF HERNANDEZ-MORENO, H.
   COLLOMBET, F.
   DOUCHIN, B.
   CHOQUEUSE, Dominique
   DAVIES, Peter
   GONZALEZ VELAZQUEZ, J. L.
AS 1:1,2,3,4;2:1,2,3;3:1,2,3;4:5;5:5;6:6;
FF 1:;2:;3:;4:PDG-DOP-DCB-ERT-MS;5:PDG-DOP-DCB-ERT-MS;6:;
C1 Univ Toulouse, F-31077 Toulouse, France.
   ISAE, Mines Albi, UPS, INSA, F-31077 Toulouse, France.
   ICA, F-31077 Toulouse, France.
   ESIME Unidad Ticoman, Inst Politecn Nacl, Mexico City 07340, DF, Mexico.
   IFREMER, Ctr Brest, Mat & Struct Grp, F-29280 Plouzane, France.
   ESIQIE IPN, Inst Politecn Nacl, Mexico City 07300, DF, Mexico.
C2 UNIV TOULOUSE, FRANCE
   ISAE, FRANCE
   ICA, FRANCE
   ESIME UNIDAD TICOMAN, MEXICO
   IFREMER, FRANCE
   ESIQIE IPN, MEXICO
SI BREST
SE PDG-DOP-DCB-ERT-MS
IN WOS Ifremer jusqu'en 2018
   copubli-france
   copubli-univ-france
   copubli-int-hors-europe
   copubli-sud
IF 0.935
TC 9
UR https://archimer.ifremer.fr/doc/2009/publication-7330.pdf
LA English
DT Article
DE ;Filament winding;Non destructive testing;Residual/internal stress;Polymer matrix composites (PMCs)
AB This paper is the first of three describing the monitoring of filament wound cylinders using Bragg grating sensors. Part I describes the technological issues and the development of specimens instrumented with embedded gratings and thermocouples. The aim is to monitor the temperature and strain changes during cylinder manufacture (see Part II) and in-service behaviour (see Part III). Specimens are filament wound glass reinforced epoxy composites, so two technological problems have to be solved: one is to collect data during fabrication and the second is to remove the specimen from the mandrel without damaging the sensors. These were accomplished by design of a specially adapted split mandrel and a rotating interface between the filament winding machine and the composite cylinder in fabrication. Immediately after sensor insertion it was possible to monitor the fabrication process, by collecting Bragg grating wavelength and temperature response, using this specially adapted tooling.
PY 2009
PD JUL
SO Applied Composite Materials
SN 0929-189X
PU Springer
VL 16
IS 3
UT 000266495300004
BP 173
EP 182
DI 10.1007/s10443-009-9085-7
ID 7330
ER

EF